[WWI] Gloss and flat finishes The solution

[Allan Wright]

Testors makes two lines of products. Their regular line, and their
premium line (called Model Master).

The Black and silver rattle cans with green or blue stripes are the
Model Master line. I actually highly prefer the Black-only cans with
yellow stripe called 'Dullcote' from their non-premium line over their
Model Master "Flat Laquer" black and silver can.

I buy the cheap-line Dullcote from my LHS by the 3-pack. They don't
normally carry it, but if I order 3 at a time they'll special order it
for me.

Allan

On Wed, 2008-12-03 at 20:41 -0500, mikemuth at ptd.net wrote:
> Er....I was agreeing with everyone who mentioned MM Lusterless. Then I
> noticed a "Yellow/Black Label on the can" was mentioned. When I went up to
> the modeling room, I found all of my rattlecans were silver with a
> black/silver label. The rings around the top were red, ghreen and blue, for
> flat, semi- and gloss....not necessarily in that order. So, do I have old
> cans or is there some other kind of MM aerosol I am missing.
> Mike Muth...anxiously awaiting D's comment on my old cans.
>