[WWI] That's nice

[Crawford Neil]

>         LOL, we have a saying in the Deep South of the US, 
> "he scratches his
> skeeter bites till they bleed". That seems to be me when it comes to
> building, I just cannot let well enough alone. I sanded the 
> undersides of
> the upper wing in an effort to get the trailing edge a little thinner,
> thinking it would be easier to restore that detail rather 
> than that of the
> top side. It went very well at first, but my just wanting it to be "a
> leeeeeetle better" caused me to bugger the trailing edge 
> detail. I haven't figured out how I will restore it, 


I would tape along the traling edge (from above), then pour in CA.
Remove the tape and sand down
a little, then turn over and tape on the other side (from below) pour in
CA, and sand some more.
This should extend the trailing edge with a layer of CA that can be
sanded to a fine edge.
It sounds much more complicated than it is, the tape is just for
ensuring that the CA runs along
the trailing edge. And yes the MAC Spad trailing edges are a PITA, I'm
not completely satisfied
with mine either, I think I left them too thick, perhaps that was lucky!
/Neil